ToToTEK.COM

Yep, that's true. I was thinking the whole time, "I'm sure they didn't screw up the cable", but it turns out that that was the case. I think it may just have been poor quality wiring insid ...

Well, I finally found the correct type of parallel cable locally and I tried it tonight and it fixed the problem!

I'm now getting "turbo" flashing without any issues! I've gone back and ...

Hi Tomy,

Ok, thank you for the reply. I appreciate it.

I did try on a second desktop machine. It still refuses to flash in turbo mode. However it does do a better job in "non-turbo" ...

Well, I PM'd and then a few days later emailed Tomy with no response. It's been over a week. I'm wondering if these cards are still going to be sold and/or supported...haven't seen them in stock in ...

Ok, thanks... I kinda thought so too. Will PM him now...

Ok, so I didn't go to bed...

I tried again, turning off "Program at turbo mode". This time I could write a ROM every so often, but after verification, I often get a dialog box saying: ...

Arghh...my login timed out and I lost my post. Powered hub doesn't help. It won't even write a 1 Mb rom past 50%. Seems to not want to write more thatn 512 Mb, no matter what I do. Bad block or so ...

I set the onboard parallel interface to EPP in the BIOS and I/O range is set at 278-027F and is set accordingly in the GUI. As far as static... No, I've not worn an anti-static wrist wrap or a grou ...

Yes, I wasn't intending to solve the problem by removing the power source, but it was simply something I tried as I was trouble-shooting for the last few hours, and decided to report here. Forget tha ...

Hello,

I've finally got a parallel port that supports the old school 278 address space working and my PCE pro only worked a couple of times and now it refuses to flash more than a few KB of data... ...