View previous topic :: View next topic |
Author |
Message |
willis82
Joined: 25 Jul 2011 Posts: 2
|
Posted: Mon Jul 25, 2011 7:25 pm Post subject: 2M super game doctor |
|
|
Found this 2M super game doctor with 2 disks labeled A/B C/D for the famicom at a local pawn shop and wondered if anyone knew what voltage power supply it took. It also has two power ports on the back so I thought someone here might know why? I'd like to start using it to get my feet wet with the famicom disk dev/disk restoring scene until I can find a MGD1 to use.
I'm new to copying famicom disks, but have been using n64 software for some time now. I started with the V64 and am now using partner N with the 64DD dev setup. |
|
Back to top |
|
|
MottZilla
Joined: 08 Sep 2004 Posts: 765
|
|
Back to top |
|
|
ericj
Joined: 09 Nov 2009 Posts: 32 Location: Oregon, USA
|
Posted: Tue Jul 26, 2011 12:59 am Post subject: |
|
|
All Famicom "copiers" use a 9V DC, Center negative, power supply.
The two ports on the back of some of the Bung units are so you can use one power supply and piggyback a male-to-male barrel plug from the copier unit to the Famicom. _________________ FDS Game Doctors | FDS Disk Writing |
|
Back to top |
|
|
willis82
Joined: 25 Jul 2011 Posts: 2
|
Posted: Tue Jul 26, 2011 1:13 am Post subject: |
|
|
ericj wrote: | All Famicom "copiers" use a 9V DC, Center negative, power supply.
The two ports on the back of some of the Bung units are so you can use one power supply and piggyback a male-to-male barrel plug from the copier unit to the Famicom. |
I tried the piggy back but the video was all garbled, could still make it out but had a lot of interference. could be the unit itself though or the fact it's running on an av famicom modded with a RGB PPU. I'll try a dedicated power supply and see what happens. |
|
Back to top |
|
|
|